0433 597 205

MATERIAL HANDLING / PROJECT EXPERIENCE

Transfer Chute Replacement

A worn transfer chute between a bucket elevator and conveyor had tight access, inconsistent historical drawings and site misalignment that made like-for-like fabrication unreliable.

WHAT HAD TO BE PROVED

The replacement would fit the real plant, control the stream and allow liner replacement inside a tight envelope.

The engineering story was geometry, wear and interfaces—not a decorative stress contour. Supports were checked for chute self-weight, liners and credible residual material.

ELEVATOR
DISCHARGE
→
IMPACT
SHELF
↘
SLIDING
ZONE
→
SKIRTED
CONVEYOR
ZONEMATERIAL STRATEGYDESIGN INTENT
Impact zoneSacrificial / thicker abrasion-resistant plateAbsorb direct stream impact
Sliding zoneReplaceable linerControl sliding wear and simplify renewal
Low-wear wallsParent plate where justifiedAvoid unnecessary liner mass and cost

DESIGN RESPONSE

Site-derived geometry, controlled stream path, replaceable wear package and installation joints positioned for the actual access envelope.

ANONYMISED PROJECTFIGURES ARE REPRESENTATIVENOT CERTIFIED RESULTS

IQ ENGINEERING GROUP

Bring the problem.
We will say what the job is.